Page 16
INSTALL BACK BRACE:
1. Take the Back Cross Brace (PN:731-2379-XX) from the packaging.
2. Using (2) mounting plate (PN:731-2379-XX), (8) m10 x 80 Hex Head Bolts (PN:731-2400), (16) m10
Washers (PN:731-2419), and (8) m10 Nyloc Nuts (PN:731-2420), install the weldment between the
two weight holders. Use (2) 17mm box wrenches to tighten these fasteners at this time.
INSTALL BAR HOLDERS:
1. Take the (4) Bar Holders (PN:731-2331) from the packaging.
2. Using (12) m10 x 135 Hex Head Bolts (PN:731-2334), (12) m10 Washers (PN:731-2419), (12) M10
Large Washers (PN:731-2346), and (12) m10 Nyloc Nuts (PN:731-2420), install the weldments to the
upright legs. Take note of the Workout Placards, make use they are facing the inside of the unit. Look
at the bottom of each placard for the number and use the image below for placement on the unit. Use
(2) 17mm box wrenches to tighten these fasteners at this time.
NOTE: Make sure you use the
right length of bolt.
