38
ENGLISH
EN
5.6.1 Separate blades
The blades are replaceable. When replacing, both
blades on the same blade bar must be replaced to
avoid imbalance.
Tightening torque:
Screws (27:P) - 24 Nm
Shear bolts (27:Q) - 9.8 Nm
In the event of a collision, the shear bolts (27:Q)
can break and the blades bend back. If this has hap-
pened, install genuine shear bolts and tighten as
above.
5.6.2 Full blade, fig. 28-29
The full blade is replaced when the edges are worn.
Install the new blade with the punched text facing
down.
Tightening torque:
5.7 Synchronising, blades
The following decks have synchronised blades:
• 92/107 M
• 107 M HD
• 121 M
If one of the blades has struck a solid object (e.g. a
stone), the positive drive belt may mesh incorrect-
ly, endangering the synchronisation. This entails a
risk of the blades colliding with each other.
Correctly synchronised blades must be offset 90°
from each other. See fig. 30.
Always check synchronisation after a collision.
If there is any suspicion of incorrect synchronisa-
tion, contact an authorised Stiga workshop for re-
pair work to be carried out.
The blades in the 110/125 Combi Pro are freely ro-
tating.
5.8 Wear protection
There are two wear protection devices on the un-
derside of the cutting deck to protect it. These can
be replaced if necessary.
6 SPARE PARTS
STIGA genuine spare parts and accessories are de-
signed specifically for STIGA machines. Please
note that ‘non-genuine’ spare parts and accessories
have not been checked or approved by STIGA:
The use of such parts and accessories
can affect the function and safety of the
machine. STIGA accepts no responsi-
bility for damage or injuries caused by
such products.
7 DESIGN REGISTRATION
This product or parts thereof is covered by the fol-
lowing design registration:
Sweden: 66 166
Germany: 499 11 740.9
France: 577 251-253, 577 439-443
USA: 435 564
GGP reserves the right to make alterations to the
product without prior notification.
110 Combi Pro 24 Nm
125 Combi Pro 45 Nm
