Turning On & Basic Operations
En-29
Using the Tuner
With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as presets for
quick selection.
You can also change the frequency steps (➔ page 60).
Tuning into Radio Stations
■ Auto tuning mode
■ Manual tuning mode
In manual tuning mode, FM stations will be in mono.
■ Tuning into stations by frequency
You can tune into AM and FM stations directly by entering
the appropriate frequency.
Listening to AM/FM Radio
This section describes the procedure of using the
buttons on the front panel, unless otherwise specified.
1
Press AM or FM to select either “AM” or “FM”.
In this example, FM has been selected.
(Actual display depends on the country.)
Band Frequency
1
Press TUNING MODE so that the AUTO indicator
lights on the AV receiver’s display.
2
Press TUNING / .
Searching stops when a station is found.
When tuned into a station, the TUNED indicator
lights. When tuned into a stereo FM station, the FM
STEREO indicator lights as shown.
Tip
• Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
manual tuning mode and listen to the station in mono.
1
Press TUNING MODE so that the AUTO indicator
goes off on the AV receiver’s display.
2
Press and hold TUNING / .
The frequency stops changing when you release the
button.
Press the buttons repeatedly to change the frequency
one step at a time.
TUNED
FM STEREO
AUTO
1
On the remote controller, press AM or FM to select
“AM” or “FM”, followed by D.TUN.
(Actual display depends on the country.)
2
Within 8 seconds, use the number buttons to enter
the frequency of the radio station.
For example, to tune to 87.5 (FM), press 8, 7, 5 or 8,
7, 5, 0.
If you have entered the wrong number, you can retry
after 8 seconds.
