$ Plug in the appliance, and turn the thermostat switch to the
USING YOUR HEATER
maximum position.
This appliance should be operated on a stable surface.
$ Then turn the heat select switch to choose cold warm or hot
If you are operating it on the floor ensure there are no
air. The operating light will illuminate.
obstructions and that objects such as newspapers are not going
$ Turn the heat select switch to the “ “ position for cool air.
to be placed on or near the appliance.
$ Turn the heat select switch to “I” for warm air: the heater
If you are operating it on a table make sure there are no other
will operate at low power.
objects in close proximity and that the heater is so placed that it
$ Turn the heat select switch to “II” for hot air: the heater will
will not fall.
operate at high power .
IMPORTANT NOTE:
Tip-Up Safety Switch
When switched on for the first time the heater may emit a small
The Tip-Up switch is designed to switch the heater off in the
amount of vapour or light smoke - this is normal. The vapour will
event that it is lifted or falls over.If the heater is placed on a very
burn off safely within a few minutes.
indented surface or on a carpet with exceptionally long, soft pile
OPERATION
the safety switch may prevent the heater from turning on.
Should this happen replace the heater on a firmer, smoother,
The heater is fan assisted. The heat select switch turns the fan on
surface.
and the heater will blow cold or warm air depending on the
setting. The thermostat controls the temperature.
Temperature Control
$ When you feel the room temperature is comfortable, turn
$ Turn the thermostat to the minimum and turn the heat
the thermostat switch anti-clockwise slowly to the
select switch to the “O” position (see picture). In this
minimum position until the appliance stops working.
position the heater is switched off and the operating light
will be extinguished.
$ The thermostat will now keep the room temperature at the
desired temperature.
$ When unplugging the power cord, hold the plug top, not
SAFETY GUIDE - PLEASE READ CAREFULLY
the power cord.
Please follow all the safety precautions listed below for safety
$ Store the appliance away from direct sunlight and out of
and to reduce the risk of injury or electrical shock.
the reach of children.
$ Read all the instructions carefully before using this
$ DO NOT touch the fan inlet or outlet when the appliance is
appliance and keep them for future reference.
operational. RISK OF BURNS
$ Retain the manual. If you pass the product on to a third
$ Do not place soft objects or fabrics over or in close proximity
party, make sure to include this manual.
to the fan or otherwise obstruct the fan inlet or outlets.
$ Unplug the appliance from the mains supply when not in
$ DO NOT insert any objects into either the air inlet or the
use, or before cleaning any part of the appliance.
outlet of the appliance.
$ This appliance is for household use only.
$ There are no user serviceable parts in your appliance.
$ Do not use outdoors or in damp or wet conditions.
Unauthorised dismantling or servicing will void the
$ Do not immerse the appliance or the electrical cord or plug
product warranty.
in liquids.
$ Do not operate the appliance with a damaged cord or plug
$ Do not use the appliance near a fire or other source of heat.
or after the appliance or any component has been
$ Place the appliance on a stable and flat surface where
damaged. Send the heater to a suitably qualified or
there is no risk of it tipping over or being knocked over.
appointed service agent for inspection and repair.
$ Ensure that there is enough space for the fan heater while
$ If a fault develops with the Tip-Up safety switch, do
operating. There should be at least 50 cm around the
not use the appliance. Have it repaired by a qualified
appliance, and the distance in front of the air outlet should
service agent before re-using it.
be at least 120 cm.
$ Do not use the appliance for any purpose not expressly
$ DO NOT place the appliance immediately below an
specified in this manual
electrical socket or other appliance.
$ THIS APPLIANCE MUST BE ATTENDED AT ALL TIMES
$ Keep flammable and explosive objects away from the heater.
WHEN IT IS SWITCHED ON
$ DO NOT hang the appliance on a wall, furniture, etc.
ELECTRICAL INFORMATION
$ DO NOT use the heater on carpets or soft floor coverings.
Before using this appliance ensure that the voltage of your
$ DO NOT use the heater in the immediate surroundings of a
electricity supply is the same as that indicated on the rating plate
bath, a shower or a swimming pool.
of the appliance.
$ DO NOT place the appliance close to children or pets. Never
THIS APPLIANCE MUST NOT BE EARTHED.
let children operate this appliance. Close supervision is
The means of disconnecting this appliance from the mains
necessary when this appliance is used near children.
supply is the mains plug. This should be unobstructed and
$ This appliance is not intended for use by persons (including
readily operable at all times .
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
SAFETY PROTECTION SWITCH
they have been given supervision or instruction concerning
If the ceramic element overheats or heat in the appliance is
use of the appliance by a person responsible for their safety.
allowed to build up to excessive levels a protection switch will
$ Children should be supervised to ensure that they do not
automatically switch the fire off. If this happens the fire will not
play with the appliance.
operate and must be taken to a qualified service facility for
repair.
Page 2 Page 3
CONTROLS AND FEATURES
Thermostat Heat select switch
Indicator light
Air outlet
Air inlet
CFH1 FAN HEATER USER GUIDE
Your heater is fan assisted for improved air circulation. The unit
INTRODUCTION
features a built-in thermostat and a safety switch which
This appliance uses a PTC heating element. PTC units heat
disconnects power to the appliance if it is tipped over.
rapidly, have no incandescent elements and have intrinsic self
regulating properties.
Tip-Up
Safety Switch
UNDERSIDE VIEW
Carry handle
