TRAXXAS
•
13
THE TRAXXAS TQ RADIO SYSTEM
The following Traxxas High
Current Connector packages
are available from your
hobby dealer. When using
adapters, be careful not to
exceed the current rating of
the Molex connector.
For best performance, it is
strongly recommended that
you use only battery packs
equipped with the Traxxas
High-Current Connector.
However, batteries with a
Molex® connector may be
used in the
model in
conjunction
with #3062
adapter.
Part #3060
Single Male/Female
Part #3080
2-Pack Female
Part #3070
2-Pack Male
Part #3061
Male Charge Adapter
Part #3062
Female Charge Adapter
INSTALLING BATTERY PACK
Your model includes a 7.2-volt battery pack. To properly balance the
model, it should be installed in the battery compartment on the left
side of the model. Follow these steps to install the battery:
Battery Installation
1. Open the battery
compartment door
by pressing on the
release tabs.
2. Install the battery
pack with the battery
wires facing the rear
of the model.
3. Route the battery
wire through the slot
near the vent.
4. Close the battery
door, making sure
not to pinch the
battery wires. Be sure
both release tabs are fully engaged with the door. Do not connect
the battery pack to the ESC at this time. Note: always unplug the
battery and remove from the model after use.
Using an Additional Battery Pack for Increased Run Time
Traxxas 1/16 models only require one battery pack, but the chassis can
accept two batteries. The 1/16 E-Revo and Slash 4WD can be run with
two battery packs to extend run time. The batteries must be connected
in parallel, which will combine the capacity of the two batteries (for
example, two 7.2-volt 1000mAh packs connected in parallel will deliver
a total capacity of 2000mAh, but total voltage will remain 7.2 volts). This
is easily done with a parallel Y-harness (part #3064, sold separately). Be
sure to only use the Y-harness with identical battery packs; do not mix
batteries of different chemistries or capacities. Never connect the two
batteries in series this will fail the ESC!
Using LiPo Battery Packs in your model.
WARNING: The XL-2.5 is not directly compatible with LiPo
batteries. The XL-2.5 is not equipped with low voltage
detection. For LiPo use, the XL-2.5 requires an external low-voltage
detector (sold separately, consult your hobby dealer).
THE TRAXXAS HIGH CURRENT CONNECTOR
Your model is equipped with the Traxxas
High-Current Connector. Standard connectors
restrict current ow and are not capable of
delivering the power needed to maximize the
output of your model. The Traxxas connector’s
gold-plated terminals with a large contact surfaces ensure positive
current ow with the least amount of resistance. Secure, long-lasting,
and easy to grip, the Traxxas connector is engineered to extract all
the power your battery has to give.
To run this model, your batteries must be equipped with Traxxas
High-Current Connectors. Batteries can either be purchased new
with Traxxas connectors installed or Traxxas connectors can be
purchased to install on battery packs you already own. See sidebar
for packages available from your hobby dealer.
Battery Wire Slot
Battery Orientation
5
When operating your model with two batteries for maximum
run time, be careful to monitor the temperature of the
speed control and motor to prevent overheating. If either
component feels excessively hot, or the speed control’s
thermal overload protection activates, stop running the
model immediately and allow the components to cool.
For best off-road handling with two battery packs, consider
installing stiffer springs on your model. Traxxas offers
accessory springs for this purpose; see the parts list included
with your model for item numbers.
Molex
connector
