9-42
Wasp WPS100 Product Reference Guide
Setup Field(s)
Table 9-1. Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor To a Character
Scan the Move Cursor To Character bar code
on page 9-43, then any printable ASCII character
from the Alphanumeric Keyboard. When this is
used, the cursor moves to the position after the
matching character. If the character is not there,
the rule fails and ADF tries the next rule.
9-43
Move Cursor to Start of Data
Scan this bar code to move cursor to the
beginning of the data.
9-43
Move Cursor Past a Character
This parameter moves the cursor past all
sequential occurrences of a selected character.
For example, if the selected character is ‘A’, then
the cursor moves past ‘A’, ‘AA’, ‘AAA’, etc. Scan
the Move Cursor Past Character bar code on
page 9-44, then select a character from the
Alphanumeric Keyboard. If the character is not
there, the cursor does not move (i.e., has no
effect).
9-43
Skip Ahead “N” Characters
Scan one of these bar codes to select the number
of positions ahead you wish to move the cursor.
9-44
Skip Back “N” Characters Scan one of these bar codes to select the number
of positions back you wish to move the cursor.
9-48
Send Preset Value
Send Values 1 through 6 by scanning the
appropriate bar code. These values must be set
using the prefix/suffix values in Table 6-4 on page
6-30.
Value 1 = Scan Suffix; Value 2 = Scan Prefix
Value 6 = FN1 Substitution Value
9-51
