4 Mount Installation
MAN0041 (Rev. 4/4/2008)
LOADER MOUNT INSTALLATION
■ Only use 111874 Loader Mounting Kit for
mounting Woods LU126, LU132, 1020, 1027 loaders
on New Holland
®
TN55, TN60A TN65, TN70, TN70A,
TN75, TN75A tractors and Case IH
®
JX1060C,
JX1070C, and JX1075C tractors. Any other use or
modification of this mounting kit may result in seri-
ous injury or death.
Safety instructions are important! Read all
attachment and power unit manuals; follow all
safety rules and safety decal information. (Replace-
ment manuals and safety decals are available from
your dealer. To locate your nearest dealer, check
the Dealer Locator at www.WoodsEquipment.com,
or in the United States and Canada call 1-800-319-
6637.) Failure to follow instructions or safety rules
can result in serious injury or death.
Do not modify or alter or permit anyone else to
modify or alter the equipment or any of its compo-
nents in any way.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
If you do not understand any part of this manual
and need assistance, see your dealer.
NOTICE
■ This equipment must be assembled and
installed on the customer’s tractor by the Woods
dealer. Dealer must thoroughly inspect equipment
and complete each item on the PRE-DELIVERY
CHECK LIST, DELIVERY CHECK LIST, and PROD-
UCT REGISTRATION from the loader manual
before equipment is released to the customer.
Tractor Preparation
For installing this mounting kit, references to right, left,
forward, and rearward directions are determined from
the operator’s position in the tractor seat.
1. Remove the tractor front weights and front fend-
ers, if equipped.
2. Rotate the exhaust pipe opening to face away
from the left side of the tractor.
NOTE: On TNA models the tip of the exhaust
pipe will have to be removed and a weather cap
installed. See page 6 for installation instructions.
3. Set the tractor wheels to the manufacturer’s
widest recommended spacing. Refer to the
tractor operator’s manual.
NOTICE
■ Clean threaded holes in the tractor chassis
thoroughly, using a tap of the proper size. Paint,
rust, or debris in the threads may not permit cap
screws to be installed and tightened correctly.
As a valued customer, Woods appreciates your comments. Once loader mount and
hydraulic hoses have been installed, please take a few minutes to complete the Loader
Mount Evaluation sheet that was supplied with this mount. Your comments will help us
continue to bring you quality products.
