4635 LPS HARDWARE COMPONENTS
Trays 1 and 2 can handle paper sized from 8 by 10 inches to 9 by
14 inches/203 by 254 mm to 229 by 356 mm.
High-capacity feeders (HCF)—
trays 3, 4, 5, and 6 Each HCF can hold up to 2,600 sheets of 20-pound/75-gsm
(5 and 6 optional) paper as small as 7 by 10 inches and including large paper sizes
such as 11.69 by 16.54 inches (A3), 11 by 17 inches (297 by 432
mm), and 10.12 by 14.33 inches (B4).
High-capacity stackers (HCS)—
bins A, B, C, and D Each HCS can hold up to 2,500 sheets of 20-pound/75-gsm
(C and D optional) paper, if a stacking container is not used. Printed sets can be
offset in the HCS for easier separation of reports.
Sample tray The capacity of the sample tray is 100 sheets of 20-pound/75-gsm
paper.
Purge tray The purge tray located at the top of the last feeder/stacker
module is where waste sheets are sent when cleared from the
printer. The purge tray can hold 100 sheets of paper.
Printer control console The printer control console located on top of the printer
contains the continue, stop, and sample buttons. The console
has a color monitor with a touch-sensitive screen which displays
detailed graphics showing jam clearance instructions and
feeder/stacker status. Printer tasks, such as lowering feeder trays
and stacker bins, can be performed by touching areas of the
console screen.
Optional bypass transport The ability to increase your production capability by adding
finishing devices to your 4635 is made possible by the Bypass
Transport option. Finishers give you the ability to choose a wide
range of finishing options, such as shrink wrapping and stitching.
The bypass transport processes simplex and duplex jobs and
accepts any type of paper that your 4635 LPS is capable of
handling (refer to the “4635 LPS overview” chapter).
Connected to the feeder/stacker, the bypass transport allows
finishing devices to interface directly with your 4635 LPS. It is
fully integrated into your 4635 LPS hardware and software
utilities, allowing you to select it at the UI or within your job
setup. The bypass transport meets the Xerox Document Feeding
and Finishing Architecture (DFA) Level 1 specifications.
Optional input enablement device The input enablement device is connected to the right side of
the feeder/stacker module and provides the means to add bulk
feeders to your 4635 LPS. Fully integrated into your 4635 LPS
hardware and software utilities, your input enablement device is
selectable at the UI or within your job setup.
Figure 3-7 shows the 4635 LPS with the optional bypass
transport.
3-6 XEROX 4635 LASER PRINTING SYSTEM PRODUCT REFERENCE
