Operator Guide Product overview
DocuTech/DocuPrint 75/90 and DocuPrint 75 MX 3-11
Stapling
Removing any of the output while the printer is running may
produce finished sets that are incorrectly stapled.
To ensure that the stapling of thin sets is satisfactory, the printer
performs the following actions.
After 30 finished sets of 15 sheets, the printer:
1. cycles down
2. raises a message to empty the Stacker
3. waits until the sets are removed
4. raises the Stacker Tray
5. cycles up and resumes printing.
If these parameters are not satisfactory for your printing, contact
Xerox.
Staple placement
For information about the limitations of portrait and landscape
staple placement, refer to the Staple Placement table below.
Table 3-1. Staple placement
Edge Feed
Orientation Media Size
Portrait
Staple
Landscape
Staple
Dual
Portrait
Staple
Dual
Landscape
Staple
Long 8.5x11 FAULT FAULT
Long 8.5x14 N/A N/A N/A N/A
Short 8.5x11 FAULT FAULT
Short 8.5x14 FAULT FAULT
Short 11x17 FAULT FAULT
