16 En
Connections
If you use two sets (A and B), the impedance of each speaker
must be 8 Ω or higher. When only using one set of speakers (A or
B), use speakers with an impedance of 4 Ω or higher.
■ Connecting the speakers
1 Remove approximately 10 mm (0.4 in) of
insulation from the end of each speaker
cable and twist the exposed wires of the
cable together to prevent short circuits.
2 Unscrew the knob and then insert the bare
wire into the hole.
3 Tighten the knob.
■ Connecting the speakers using the
banana plug
(Except for Europe models)
First, tighten the knob and then insert the banana
plug into the end of the corresponding terminal.
■ Connecting the speakers using the
Y-shaped lug
1 Unscrew the knob and then sandwich the
Y-shaped lug between the ring part and base.
2 Tighten the knob.
Caution
10 mm (0.4 in)
Banana plug
Y-shaped lug
Slide
