Filter
Top Products
43
2.
The D-Link Air DWL-650 Configuration
screen appears.
3. Select the Configuration tab.
4. In the Mode field, enter Infrastructure.
5. In the SSID field, enter the word “2WIRE”
followed by the last three digits of your
HomePortal serial number. This is the Wireless
Network Name. The Wireless Network Name is
case-sensitive, so it is important that you enter
the word “
2WIRE” in capital letters.
6. In the Tx Rate pull-down menu, verify that
Fully Automatic is selected (this is the default).
7. In the PS Mode pull-down menu, verify that
Disabled is selected (this is the default).
8. Click Apply Changes.
9. Select the Encryption tab.
10. From the Encryption (WEP) pull-down menu,
select
64 Bit.
11. In the WEP Key Entry field, select the Manual
Entry
radio button.
12. In the Key 1 field, enter your ten-digit Wireless
Encryption Key, located on the bottom of your
HomePortal.
13. From the Default Tx Key pull-down, select 1.
14. Click Apply.
15. Click OK.