Filter
Top Products
Gateway Installation and Support Guide
4
Running the 2Wire Setup Wizard Manually
If after one minute the Setup Wizard does not automatically run:
Windows Users: Double-click the
My Computer icon located on the desktop.
Double-click the icon that corresponds to your CD-ROM drive.
Double-click
Setup.exe and follow the on-screen instructions.
Mac Users: Double-click the
2Wire icon.
Double-click the
2Wire Setup Wizard icon.
Verifying That Your PC Adapter Driver is Installed Correctly
There are two common errors that may occur during installation that will result in an error message:
• The appropriate adapter driver software was not installed.
• The adapter driver software was only partially installed or is incompatible with your system.
Follow the procedure appropriate to your system to determine whether the driver was correctly installed.
Windows XP: 1. Click
Start and click Control Panel.
2. Double-click the
System icon.
3. Select the
Hardware tab, then click Device Manager.
Continue to step 4 under Accessing Driver Status on page 5.
Windows 2000: 1. Click
Start >Settings and click Control Panel.
2. Double-click the
System icon.
3. Select the
Hardware tab and click Device Manager.
Continue to Step 4 under Accessing Driver Status on page 5.
Windows 98 SE or Windows ME:
1. Click
Start >Settings and click Control Panel.
2. Click the
System icon.
3. Select the
Device Manager tab.
Continue to Step 4 under Accessing Driver Status on page 5.