Filter
Top Products
Connect the First Computer to the Gateway
5
Wireless Connection
Requires wireless-enabled notebook or a computer with an 802.11b/g wireless network adapter installed.
Wireless adapters can be purchased from your service provider.
Figure 2. Gateway Connected Via Wireless
1.
Connect the provided AC power adapter from the 2Wire gateway’s POWER port to an electrical outlet.
The
POWER light on the front of the gateway should be green.
2. Connect the provided gray telephone cable from the gateway’s PHONE LINE port to a telephone jack with
DSL service.
3. Install your wireless adapter according to the manufacturer’s instructions (see note below).
Note: Security of the 802.11g wireless connection associated with this 2Wire 2701HGV-W
ADSL2+ Router is the customer’s responsibility. Telecom will take no responsibility for
charges made to customer’s accounts due to poorly organized wireless security allowing
unknown users to connect to the internet via this wireless router. Should this occur, do not
complain to the Telecom Fault Service or Jetstream Helpdesk.
Note: If you use a 2Wire wireless adapter (PC card or USB adapter) for wireless networking,
the 2Wire CD automatically configures it to communicate with the gateway during setup. If
you are NOT using a 2Wire wireless adapter, you must manually configure your adapter to
communicate with the gateway using the information on page 6.