Filter
Top Products
10
3. Select the Configuration tab.
4. In the Mode field, enter Infrastructure.
5. In the SSID field, enter the word “2WIRE” followed by the last three digits of your HomePortal serial
number. This is the Wireless Network Name. The Wireless Network Name is case-sensitive, so it is
important that you enter the word “
2WIRE” in capital letters.
6. In the Tx Rate pulldown menu, verify that Fully Automatic is selected (this is the default).
7. In the PS Mode pulldown menu, verify that Disabled is selected (this is the default).
8. Click Apply Changes.
9. Select the Encryption tab.
10. From the Encryption (WEP) pulldown menu, select 64 Bit.
11. In the WEP Key Entry field, select the Manual Entry radio button.
12. In the Key 1 field, enter your ten-digit Wireless Encryption Key, located on the bottom of your
HomePortal.