Filter
Top Products
20 CHAPTER 1: INTRODUCING THE 3COM SWITCH 4050 AND 4060
Default Settings Table 5 shows the default settings for the 3Com Switch 4050 and 4060.
If you initialize one of the Switch units, it is returned to these defaults.
Table 5 Default Settings
Feature 3Com Switch 4050/4060
Port Status Enabled
Port Speed Auto-negotiated
Duplex Mode Auto-negotiated
Flow Control Auto-negotiated
Broadcast Storm Control Enabled
High threshold: 3000 broadcast frames per
second — Notify and filter
Low threshold: 1500 broadcast frames per
second — Notify and unfilter
Virtual LANs (VLANs) All ports belong to the untagged Default VLAN
(VLAN 1)
Multicast Filtering IGMP filtering enabled
Rapid Spanning Tree Protocol Enabled
Link Aggregation Control
Protocol (LACP)
Enabled
Spanning Tree Protocol Enabled
Smart Auto-sensing Enabled
IP Address 169.254.100.100
*
* This default IP address is used if the unit is operating in standalone mode, and/or no other
Switches on the network have this IP address. If this default IP address is already in use then the
Switch detects this and configures itself with an IP address in the range 169.254.1.0 to
169.254.254.255.
Subnet Mask 255.255.0.0