Filter
Top Products
Configuring Link Aggregation 43
Complete Configuration
1 In manual aggregation mode
#
link-aggregation group 1 mode manual
#
interface Ethernet1/0/1
port link-aggregation group 1
#
interface Ethernet1/0/2
port link-aggregation group 1
#
interface Ethernet1/0/3
port link-aggregation group 1
#
2 In static LACP aggregation mode
#
link-aggregation group 1 mode static
#
interface Ethernet1/0/1
port link-aggregation group 1
#
interface Ethernet1/0/2
port link-aggregation group 1
#
interface Ethernet1/0/3
port link-aggregation group 1
#
3 In dynamic LACP aggregation mode
#
interface Ethernet1/0/1
lacp enable
#
interface Ethernet1/0/2
lacp enable
#
interface Ethernet1/0/3
lacp enable
#
Precautions ■ If static LACP aggregation or manual aggregation is adopted, you are
recommended not to cross-connect the aggregation member ports at the two
ends to avoid packet loss. For example, if local port 1 is connected to remote
port 2, do not connect local port 2 to remote port 1.
■ Dynamic LACP aggregation mode is not recommended in actual networking
scenarios.
■ The implementation of static aggregation varies by platform software version.
This may result in problems when products using different platform software
versions are interconnected through static aggregation groups. Use the
display version command to view the platform software version.
■ The Switch 4210 supports only the manual aggregation mode.