Filter
Top Products
34 Chapter 3: Starting and Configuring the Router 6000
Checking/Operating after power-on
After powering on the router, check that:
■ The LEDs on the front panel show that the router is operating
normally.
For description on LED behaviors, refer to the section “Generic Modules”.
■ The console terminal displays normally.
After you power on the router, you can see the startup banner (refer to
the section “Boot Process of the RPU2”). After the boot process or
power-on self-test (POST) completes, press <Enter> as prompted and
proceed to configure the router when the command line prompt
<3Com> appears.
Boot Process of the
RPU2
The Boot ROM runs at startup of the router. The terminal displays the
following banner:
The banner varies by Boot ROM version.
System starts booting ... (1.01)
*******************************************
* *
* 3Com 6000 Router, 10.05 *
* *
*******************************************
Copyright© 2003-2004 by 3COM-3COM TECH CO., LTD.
Compiled at Wed Jul 20 16:35:23 EDT 2005
Testing memory...OK!
512M bytes SDRAM Memory
Hardware Version is 2.0
CPLD Version is 1.0
Press Ctrl-B to enter Boot Menu 0
Press <Ctrl+B> to have the system enter Boot Menu. Otherwise, the
system starts decompressing the program and displays:
System is
self-decompressing......................................
OK!