Filter
Top Products
6-44
CHAPTER 6: COMMAND LINE INTERFACE
Command Mode
Exec
Example
SNMP Commands
Controls access to this access point from management stations using the Simple
Network Management Protocol (SNMP), as well as the hosts that will receive trap
messages.
Table 16 SNMP Commands
Outdoor 11a Building to Building #show dhcp-relay
DHCP Relay : ENABLED
Primary DHCP Server : 192.254.2.10
Secondary DHCP Server : 0.0.0.0
Outdoor 11a Building to Building #
Command Function Mode Page
snmp-server community Sets up the community access string to permit access
to SNMP commands
GC 6-46
snmp-server contact Sets the system contact string GC 6-46
snmp-server location Sets the system location string GC 6-47
snmp-server enable server Enables SNMP service and traps GC 6-48
snmp-server host Specifies the recipient of an SNMP notification
operation
GC 6-48
snmp-server trap Enables specific SNMP notifications GC 6-49
snmp-server engine id Sets the engine ID for SNMP v3 GC 6-51
snmp-server user Sets the name of the SNMP v3 user GC 6-52
snmp-server targets Configures SNMP v3 notification targets GC 6-53
snmp-server filter Configures SNMP v3 notification filters GC 6-54
snmp-server
filter-assignments
Assigns SNMP v3 notification filters to targets GC 6-56
show snmp groups Displays the pre-defined SNMP v3 groups Exec 6-56
show snmp users Displays SNMP v3 user settings Exec 6-57
show snmp
group-assignments
Displays the assignment of users to SNMP v3 groups Exec 6-57
show snmp target Displays the SNMP v3 notification targets Exec 6-58