Filter
Top Products
Installation Requirements and Recommendations 27
The WX1200 supports 10/100 Ethernet connections. Table 8 lists the link
type and properties of the supported connections.
10/100 Ethernet Cable Wiring Connections on the 10/100 ports
require Category
5 (Cat 5) cable based on the EIA/TIA-586 standard. For
direct connection to a MAP access point, a router, or an end station such
as a PC, printer, or server, use a straight-through cable. For direct
connection to another switch, use a crossover cable. (The 10/100
Ethernet ports on the WX1200 switch provide automatic MDI/MDX,
which automatically crosses over the send and receive signals if required.)
Table 9 on page 28 lists the pin signals for 10/100 Ethernet
straight-through wiring. Pins 4, 5, 7, and 8 are used only when Power
over Ethernet (PoE) is enabled on the port. RD means Receive Data and
TD means Transmit Data.
1000BASE-LX Single mode 9/10-µm fiber SC 10,000 m
(32,808.4
feet)
Multimode 50-µm fiber SC 550 m
(1804.5
feet)
Multimode 62.5-µm fiber SC 550 m
(1804.5
feet)
1000BASE-TX Cat 5 copper
Can use straight-through or
crossover signaling, provided all four
wire pairs are connected
RJ-45 100 m
(328
feet)
Table 8 Ethernet Interfaces
Link Type Cable Type
Connector
Type
Maximum
Distance
10/100BASE-T Cat 5 copper
Straight-through or
crossover signaling
RJ-45 100 m
(328
feet)
Table 7 Ethernet Interfaces (continued)
Link Type Cable Type
Connector
Type
Maximum
Distance