Filter
Top Products
E-12
Operating
Switch on the projector power
Press the STANDBY button on the remote control
or the projector.
5
The first time the power is switched on after pur-
chase, [Menu Language Select] will be displayed.
See Page E-13
• The STANDBY indicator starts flashing green, then
stops flashing, remaining lit, after about 60 sec-
onds. If the STATUS indicator lights up green at
the same time, the lamp mode is set to the Eco-
mode.
If the “Password” input window is displayed:
The correct password must be input or the projector
cannot be used. For instructions on inputting the
password, refer to the operating instructions (on the
CD-ROM). For instructions on turning off the power,
see page E-14.
The projector is now capable of regular projec-
tion.
Note:
• The image can be muted quickly by closing the
lens cover while the image is being projected.
STANDBYSTATUS STANDBYSTATUS STANDBYSTATUS
Flashing green
(Approximately
60 seconds)
Lit green
Power is on
Lit amber
Precautions
● When the power plug will be unplugged from the power outlet, please place the projector near the
power outlet so that it may be reached easily.
● Press the STANDBY button after the STANDBY indicator is lit in amber.
STANDBYSTATUS
(button on main unit)
Switch on the power of the connected equipment
Select the input
Main unit operation: Press the SOURCE button.
Remote control operation: Press the desired button from among the input selection buttons.
6
7