Filter
Top Products
E-15
STANDBY
STATUS
MENU
S
O
U
R
C
E
DCM
Note
Should the projector not project properly, see the Troubleshooting section of the User’s Manual (CD-
ROM Edition).
The indicators on the projector’s control
panel light or flash to notify of problems, as
described below.
STATUS Indicators
Should an indicator be in a condition other than normal or flash at a rate other than the aforementioned, disconnect
the power cable and contact your store of purchase.
STANDBY Indicators
Indicator status
What you should do
It is time to replace the lamp.
Replace with a new lamp cartridge.
The lamp has reached the end of its service life.
The power will no longer turn on.
The projector can be used for 100 hours after the lamp
has reached the end of its service life.
Replace with a new lamp cartridge.
The lamp cover is open.
The lamp cover is not properly mounted. Mount it prop-
erly.
The temperature is abnormally high.
• The temperature protector has been activated. If the
room temperature is high, move the projector to a cool
place. If the projector’s internal temperature is high, check
the cooling fan’s ventilation slots and clean them if they
are clogged.
• When the temperature protector is activated, the power
turns off and in some cases will not turn back on imme-
diately. In this case wait about 90 seconds, then try again.
The fan has stopped.
Unplug the power cable and contact a store that sells
the PX5 for repairs.
The lamp will not light.
Wait at least 90 seconds, then turn the power back on.
If the problem persists, unplug the power cable and
contact a store that sells the PX5 for repairs.
STATUS
Flashing red
(lit for 1 seconds/
off for 1 seconds)
STATUS
Lit red
STATUS
Lit red
STATUS
Flashing red
(lit for 1 seconds/
off for 1 seconds)
STATUS
Flashing red
(lit for 0.5 seconds/
off for 0.5 seconds)
STATUS
Flashing red
(lit for 0.5 seconds/
off for 0.5 seconds)
Lit amber
Lit red
Lit red
Flashing amber for 60
seconds, then lit amber
STANDBY
When the Power is on
(Lit green)
Standby (Lit amber)
When the lamp has
burned out during use:
Flashing amber for 90
seconds, then lit amber.
When the lamp does not
come on from the start:
Lit amber
STANDBY
STANDBY
STANDBY
STANDBY
STANDBY
When an indicator is lit or flashing