3M S40 Projector User Manual


 
30
The lamp indicator is also red when the lamp unit reaches high temperature.
Before replacing the lamp, switch power OFF, wait approximately 20 minutes, and switch power
ON again. If the lamp indicator is still red, replace the lamp.
NOTE
Replacing the lamp
All projector lamps will wear out eventually. If used for long periods of time, the image could become
darkened, and the color contrast could be impacted as well. We recommend that you replace your lamps
early. If the lamp indicator turns red, or a message prompts you to replace the lamp when you power up
the projector, the lamp needs to be replaced. (See "Related Messages" ( ) and "Regarding the
Indicator Lamps" ( ) for details.)
1
Turn off the projector, and unplug the
unolug the power cord.
Allow the lamp bulb to cool for at
least 45 minutes, and prepare a new
lamp.
5
Insert the new lamp, and tighten the 1
screw firmly to lock it in place
Also steadily push the opposite side of the
screwed side of the
lamp into the unit.
6
Replace the lamp
door, and tighten
the 2 screws firmly
to lock it in place
7
Slowly turn the projector so that
the top is facing up
2
After making sure that the projector has
cooled adequately, slowly flip over the
projector, so that the bottom is facing up
3
Unscrew the 2
screws, and
remove the
lamp door
4
Unscrew the 1 screw, and slowly pull
out the lamp by the handle
Be careful not to touch the inside of the lamp case.
ATTENTION
Make sure that the screws are screwed in firmly. Loose screws could result in damage or injury.
Do not use with lamp door removed.
Do not reset the lamp timer without replacing the lamp. Reset the lamp timer always when replacing
the lamp. The message functions will not operate properly if the lamp timer is not reset correctly.
When the lamp has been replaced after the message of "CHANGE THE LAMP ...THE POWER
WILL TURN OFF AFTER 0 hr." is displayed, or the lamp indicator is red, complete the following
operation within 10 minutes of switching power ON.
8
Turn on the projector power, and using
the menu, reset the lamp timer
To reset the lamp timer, from the OPTION
menu, select LAMP TIME. (See OPTION
menu ( ) for details.)
34
35
28