Filter
Top Products
-12-
MPG-301 One-Axis Pulse Generation Encoder Counter Board 1M PPS 1-axis pulse output
1M PPS encoder input, etc.
[Characteristics]
MPG-301 is a pulse-generation multifunction board which is loaded with one Kyopal X3202 and let MPC816 directly
operate the IC register. It is capable of flexible control such as changing pulse rate during pulse generation, referring to
the present position, S-shape acceleration/deceleration, etc.
[Specification]
Power source: DC 12V~24V
Control I/O: One-axis RS422 driver pulse output. One-axis RS422 encoder input.
Z-phase input, limit input, etc.
Consumed current:150 mA
[Accessories] (1) Power connector (H4P-SHF-AA) JST *1
(2)Contacts (BHF-001T-0.8SS) JST *4
MPG-303 PG Board 2-Axis + 2-Axis Pulse Generation
[Characteristics]
This is a pulse-generation board based on 2-axis linear interpolation. It is supported by the commands of TNYFSC
interpreter installed in MPC-816. Also, MPC-816 supports three MPG-303 boards. In the standard P version, MODE
5 and MODE 6 are used. The maximum pulse rate is 50 kpps. As for the output axis, two axes can be used at an
exclusive time from either the XY or ZU axis.
[Specification]
Power source: DC 5V~24V (for I/O control).
Control I/O: 4-axis pulse output port (photo-isolated, open collector).
8-point origin-returning sensor.
Maximum pulse rate: 50 kpps CW/CCW2 pulse method.
Consumed current: 80 mA
[Accessories] (1) Connector (HIF-3BA-16D-2.54R) Hirose *2
(2) Power connector (H4P-SHF-AA) JST *1
(3) Contacts (BHF-001T-0.8SS) JST *4
MCT-801 (Conserved Item) Counter Board
[Characteristics]
This is a 24-bit up-down counter equipped with an encoder/decoder. It deals with both encoder input and pulse input.
The input interface is optoisolated. Although a rotary encoder with 12V power is assumed in the ship-out setting, it can
deal with DC 5V and DC 24V by changing the resistor array. Up to two MCT-801s can be used in one system.
[Specification]
A-B-phase phase encoder input / Up-down pulse input
Compatible with 500 kpps. Power source: DC 5V ~ DC 24V
Consumed current: 20 mA
[Accessories] (1) Connector (PS-16SEN-D4P1-1) JAE *1
MCD-001 (Conserved Item) Data Memory Card
[Characteristics]
This is an interface board for supporting a memory card (32 kbyte) made by Fujisoku. When MCD-001 is used,
an array of 10921 is extended as M() on the memory card. By utilizing this numerical data area, switching is
performed of the model that used the IC card, storing a large amount of data, etc. Also, MCD-001 is equipped
with four digi-switches, enabling a read-out of values by the commands. MPC-816 supports one MCD-001.
[Specification]
IC card: Made by Fujisoku (BS32D1-A)
Consumed current: 10 mA
[Accessories] (1) Memory card (BS32D1-A) *1
(1)
(2)
(2)
(1)
(3)
(1)
MEMORY
CARD
(1)