AccuFitness 2400 Network Cables User Manual


  Open as PDF
of 20
 
1-12 Microprocessor Upgrade Installation Guide
DELL CONFIDENTIAL - Preliminary 9/11/00
(Rev. 11/3/98) FILE LOCATION: S:\SYSTEMS\SlimFast\ts\ProcUpgrade\028WD\028wdeb0.fm
8SJUDGLQJWKH0LFURSURFHVVRURU
,QVWDOOLQJD6HFRQGDU\0LFURSURFHVVRULQ
3RZHU(GJH6\VWHPV
Each microprocessor is contained within an SEC cartridge and heat sink assembly.
The system board has two guide-bracket assemblies, which hold the SEC cartridge
and heat sink assemblies. If your system has only one microprocessor, the secondary
guide-bracket assembly must contain a terminator card.
If you add a second microprocessor to the system, its maximum speed need not
match that of the primary microprocessor, but the internal operating speed of the
faster microprocessor will be reduced to match the speed of the slower
microprocessor.
127,&(,I\RXDUHXSJUDGLQJDV\VWHPE\LQVWDOOLQJDVHFRQGDU\PLFURSUR
FHVVRU\RXPXVWRUGHUDQXSJUDGHNLWIURP'HOO7KHXSJUDGHNLWIURP'HOO
FRQWDLQVWKHFRUUHFWYHUVLRQRIWKHPLFURSURFHVVRUIRUXVHDVDVHFRQGDU\
PLFURSURFHVVRU
5HPRYLQJD7HUPLQDWRU&DUG
To remove a terminator card, perform the following steps.
:$51,1*%HIRUH\RXSHUIRUPWKLVSURFHGXUH\RXPXVWWXUQRIIWKHFRP
SXWHUDQGGLVFRQQHFWLWIURPLWV$&SRZHUVRXUFH)RUPRUHLQIRUPDWLRQVHH
6DIHW\)LUVW³)RU<RXDQG<RXU&RPSXWHULQWKH'HOO3RZHU(GJ H6\VWHPV
,QVWDOODWLRQDQG7URXEOHVKRRWLQJ*XLGH
1. Turn off the system, including any attached peripherals, and disconnect the AC
power cable from its power source.
127,&(6HH3URWHFWLQJ$JDLQVW(OHFWURVWDWLF'LVFKDUJHLQWKHVDIHW\
LQVWUXFWLRQVDWWKHIURQWRI\RXUV\VWHP,QVWDOODWLRQDQG7URXEOHVKRRWLQJ
*XLGH
2. Remove the computer cover.
3. Remove the cooling shroud.
4. Lift the latches on each end of the guide-bracket assembly (see Figure 1-7).
 previous next