Filter
Top Products
Installing the Mylex Disk Array Controller as the Primary Windows NT 4.0 Controller
3-4 PCI Disk Array Controller Drivers Manual
9. Select the appropriate controller from the list of controllers displayed
on this screen and press <Enter>.
10. If you have drivers to install for other controllers (for example, an
on-board SCSI or IDE controller to run other devices such as a CD-
ROM drive, etc.), repeat Step 6 and Step 7. Then when prompted, insert
the manufacturer’s supplied hardware support disk, press <Enter>, and
select the appropriate driver from the list.
If you have no other drivers to install, or when you have finished
installing other drivers, simply press <Enter> to continue installation.
11. Insert Windows NT 4.0 setup diskette #3 when prompted.
12. Follow the on-screen instructions to continue Windows NT 4.0
installation, inserting the Windows NT CD-ROM into the CD-ROM
drive when prompted. Press <Enter> and continue with the next few
Windows NT 4.0 installation screens.
13. When prompted again for the “MDAC Software Kit” diskette, insert
the NT4/NW Drivers Software Kit diskette into the floppy disk drive
and press <Enter>.
If you installed other drivers from other diskettes, you will be asked to
reinsert those diskettes as well.
This concludes Mylex Disk Array Controller driver installation for Windows
NT 4.0. Follow the on-screen instructions to complete your installation of
the Windows NT 4.0 operating system.