Filter
Top Products
3 Troubleshooting my computer68
If you still encounter problems after going through the corrective
measures, please contact your dealer or an authorized service center
for assistance. Some problems may be solved using the BIOS Setup
Utility.
One or more I2O Block
Storage Devices were
excluded from the
Setup Boot Menu
There was not enough room in the IPL table to
display all installed I2O block-storage devices.
Operating system not
found
Operating system cannot be located on either
drive A: or drive C:. Enter Setup and see if fixed
disk and drive A: are properly identified.
*Parity Check 1 nnnn Parity error found in the system bus. BIOS
attempts to locate the address and display it on
the screen. If it cannot locate the address, it
displays nnnn. Parity is a method for checking
errors in binary data. A parity error indicates that
some data has been corrupted.
*Parity Check 2 nnnn Parity error found in the I/O bus. BIOS attempts to
locate the address and display it on the screen. If
it cannot locate the address, it displays nnnn.
Press <F1> to resume,
<F2> to Setup, <F3> for
previous
Displayed after any recoverable error message.
Press <F1> to start the boot process or <F2> to
enter Setup and change the settings. Press <F3>
to display the previous screen (usually an
initialization error of an Option ROM, i.e., an
add-on card). Write down and follow the
information shown on the screen.
Run the I2O
Configuration Utility
One or more unclaimed block storage devices
have the Configuration Request bit set in the LCT.
Run an I2O Configuration Utility (e.g. the SAC
utility).
Error Messages Corrective Action
TM230-280-e.book Page 68 Tuesday, December 17, 2002 4:15 PM