Filter
Top Products
Chapter 4 52
USB eModule Error Messages
SMBIOS eModule Error Messages
CPU eModule Error Messages
MPS Table (Multi-processor) eModule Error Messages
Message
Displayed
Description
Warning!
Unsupported
USB device
found and
disabled!
This message is displayed when a non-bootable USB device is enumerated and disabled
by the BIOS.
Warning! Port
60h/64h
emulation is
not supported
by this USB
Host
Controller!
This message is displayed to indicate that port 60h/64h emulation mode cannot be enabled
for this USB host controller. This condition occurs if USB KBC emulation option is set for
non-SMI mode.
Warning! EHCI
controller
disabled. It
requires 64bit
data support in
the BIOS.
This message is displayed to indicate that EHCI controller is disabled because of incorrect
data structure. This condition occur if the USB host controller needs 64-bit data structure
while the USB is ported with 32-bit data structure.
Message Displayed Description
Not enough space in Runtime area!!. SMBIOS data
will not be available.
This message is displayed when the size of the
SMBIOS data exceeds the available SMBIOS
runtime storage size
Message Displayed Description
Warning! This system board does not support the
power requirements of the installed processor. The
processor will be run at a reduced frequency, which
will impact system performance. area!!. SMBIOS
data will not be available.
This message is displayed when the power
requirements of the board do not match the power
requirement of the CPU.
Message Displayed Description
Insufficient Runtime space for MPS data! System
may operate in PIC or Non-MPS mode.
This message is displayed when there is not enough
space in the 0F000h runtime area for creating MPS
table.