Acer PD724W Projector User Manual


  Open as PDF
of 59
 
13
... English
Installation
Powering On/Off the Projector
Power
Powering On the Projector
1. Openthelenscap.
2. Ensurethatthepowercordandsignalcablearesecurely
connected.ThePowerLEDwillash
amber
.
3. Turn on the lamp by pressing “Power” button on the control
panel.
AndthePowerLEDwillturn
amber
.
4. Turnonyoursource(computer,notebook,videoplayer
,etc.).Theprojectorwilldetectyoursourceautomatically.
If the screen displays "Lock" & "Source" icons, it means the pro-
jector locks on this source type and there is no such type of input
signal found.
If the screen displays “No Signal”, please make sure the signal
cables are securely connected.
If you connect multiple sources at the same time, using the
“Source” button on the remote control or control panel to switch.
Turn on the pro
-
jectorrstandthen
the signal sources.
1
The lens cap must
be open then turn
on the projector.
r
If the projection lens cap is not opened when a projector is powered
on, users will hear a continuous two-beep sound, and the interval of
each two-beep warning message is about 3 seconds.
r
The projector will not be turned on and automatically gone to a stand-
by mode if the lens cap is still closed after two-beep sound keeps
warning for 5 times.
r
If the projection lens cap is accidentally closed while the projector
is running, users will hear the same beep and the projector will
automatically go to a stand-by mode if the lens cap is still not opened
after 5 times of warning message.
 previous next