Filter
Top Products
GRN4-610 Chapter 5: Maintenance 54 of 73
Mounting the cutter holders
Follow the steps below to mount the cutter holders.
1. Clean the knife pocket and the cutter holder.
2. Insert the cutter holder into the pocket.
NOTE: Cutter holder must slide in easily. Do NOT damage the cutter holder surfaces
with a hammer.
3. Attach the cutter holder mounting bolts (DIN912 – M8x25 – 12.9) and add some
Loctite.
4. Make sure that the cutter holder fits properly.
5. Tight the cutter mounting bolts using a torque wrench. The required torque for
the cutter holder mounting bolts is 39 Nm. (Refer to torque values table.)
6
7
3
5
4
1
6
(1) Bed knife
(2) Bed knife mounting
screws
(3) Bed knife holder
(4) Cover plates
(5) Bed knife adjusting
screw
(6) Cover plate holder
(7) Cover plate mounting
screws