Filter
Top Products
Erasing Diagnostic Trouble Codes and Data
Erasing allows the PocketScan
TM
Code Reader to delete the codes
and I/M Monitor status from the vehicles computer modules.
Only Erase Diagnostic Data after checking
system completely and writing down results.
Avoid Cooling Fan! Fan may turn on
during test.
1.Turn Ignition Key to the Off Position.
2. Locate and Plug in Data Link
Connector (DLC.)
NOTE: The data link connector
should be located under
the dashboard on the
driverside of the vehicle.
If the data link connector is not located under the
dashboard as stated, a label describing the location of
the data link connector should be there.
3. Observe Display toggles between
Pocket and Scan.
4.Turn Ignition Key to the ON Position
leaving Engine Off.
NOTE: Make sure that the Ignition Key is
ON and NOT in the Accessory
Position.
IMPORTANT
!
WARNING
O
F
F
O
N
O
F
F
O
N
Scan
10