Filter
Top Products
Local Configuration LTPS-UM-8013-03
30 August 30, 2002 D3LX CO and RMT Modules
PERFORMING SYSTEM MAINTENANCE
Use this procedure to perform the system maintenance commands
listed.
1 From the Main menu, select 6. System Maintenance.
2 From the System Maintenance menu, select
• 1. Force/APS Commands, and then select
1. Commands for Optical Facilities to view
and force line protection for the available circuits,
• 2. Reset/LED Test Commands to reset the selected
D3LX module or verify that its LEDs are working properly,
• 4. Loopback Status Commands, and then select 1,
High/Low Speed Loopback Status/Commands
to view the loopback status or perform loopbacks on the
selected D3LX, or
• 8. Trouble Isolation (as shown in Figure 18 on
page 31), and then select the Group and Slot.
3 Use , , , ,
and to select the group and slot to
display, populate each data field according to your requirements,
then assign the selections by pressing .
6. System Maintenance
1. Force/APS Commands
2. Reset/LED Test Commands
3. Execute ACO (Alarm Cut-Off)
4. Loopback Status/Commands
5. Display Inventory
6. Display Circuit IDs
7. SCU-860 Data Transfer
8.Trouble Isolation
9. Metallic Loop Qualification
(MLQ Capable Chassis Required)
SPACEBAR
← →
↓ ↑
ENTER