Filter
Top Products
About This Manual December 20, 2004
xii LTPH-UM-1261-01
INSPECTING YOUR SHIPMENT
Upon receipt of the equipment:
• Unpack each container and visually inspect the contents for signs of damage. If the equipment has been dam-
aged in transit, immediately report the extent of damage to the transportation company and to ADC. Order
replacement equipment, if necessary.
• Check the packing list to ensure complete and accurate shipment of each listed item. If the shipment is short
or irregular, contact ADC as described in Appendix E: Product Support on page E-1. If you must store the
equipment for a prolonged period, store the equipment in its original container.
DANGER
To prevent electrical shock, be careful when working near HDSL loops and telecommunications
circuits. Coming in contact with high electrical potential will result in death or severe personal
injury.
!
IMPORTANT
The shelf chassis must be properly grounded to ensure personal and equipment safety.
DANGER
To prevent electrical shock, never install telco equipment in a wet location or during a lightning
storm. When installing or modifying telco lines, disconnect lines on the network side before
working with uninsulated lines or terminals.
DANGER
To prevent electrical shock, be careful when working near power supplies. Telco equipment uses
-48 Vdc office power.
ATTENTION
Electronic components can be damaged by electrostatic discharge (ESD). Before handling circuit
cards, wear an antistatic discharge wrist strap to prevent damage to electronic components.
Place components in static-shielding protective bags when transporting or storing. When
working on components, always place them on an approved antistatic mat that is electrically
grounded.