Filter
Top Products
Delete RAID Disk Drive
1. Press Ctrl+J when prompted to enter the RAID BIOS.
2. At the next screen select Delete RAID Disk Drive, press Enter.
3. Use arrow keys • and •to select the array you want to delete, use the
“space” key to mark the selected array, then press DEL.
4. When asked ALL DATA ON THE RAID WILL LOST!! ARE YOU SURE TO
DELETE (Y/N), press Y to accept.
Solve Mirror Conflict
When a RAID set is created, metadata which includes drive connection
information is written to the disk. If after a disk failure, the drive that failed was
replaced by a disk that was previously part of a RAID set (or used in another
system), it may have conflicting metadata. This will prohibit the RAID set from
being either created or rebuilt. In order for the RAID set to function properly, this
old metadata must be first overwritten with new metadata. To resolve this, from
the main RAID BIOS window select Solve Mirror Conflict, then press Enter, the
correct metadata, including the correct drive connection information, will be
written to the replacement disk.
Rebuild Mirror Drive
If a failure on one member occurs, you will be notified by the
RAID BIOS during boot. The steps below will guide you in rebuilding
a failed mirror set.
1. Replace the failed drive with one of equal or greater capacity, then start the
computer.
2. During boot press Ctrl+J to enter the RAID BIOS.
3. Select Rebuild Mirror Drive press Enter.
4. Use arrow keys • and •to select the array you want to rebuild, press
Enter.
5. Use arrow keys • and •to select the destination disk, press Enter.
6. When rebuilding is finished, select Save And Exit Setup, press Enter.
When asked Save to disk &Exit (Y/N)?, press Y to exit the BIOS.
Steps:
1. JMB36X RAID Configurer installation
Note: To create raid volumes and monitor the status of your raid set, you need
to install the JMB36X RAID Configurer. Install the utility from the CD
that came with your package.
a. Turn computer ON. Insert Host Controller Driver Disk into CDROM.
b. The Addonics Technologies Driver Disk window pops up.
c. Select Other Controllers. Click the ADI2S3GPX1-2E. Extract the files
into your system.
d. Install JMB36X RAID Configurer by clicking the Setup.exe. Follow the
instructions.
e. After software installation, reboot the system.
2. To open the JMB36X RAID Configurer, click on the system tray the JMicron
Icon.
3. This will open up the JMB36X RAID Configurer.
Create
RAID
Create
RAID from
Existing Disk
Show Disk
Rebuild
RAID
Remove
RAID