Filter
Top Products
Overview 5-3
5-
Overview
This section describes normal operating features of the
4000/7000DLT Series. Additionally, it explains how, and
when, to clean the tape head. This section also describes how
to clean the enclosure.
Power-on Self-Test
When you turn system power
ON
, the DLT drive performs a
Power-on Self-Test (POST). The sequence of events is:
• The LEDs on the right front panel of the DLT drive will
turn on sequentially from top to bottom. All LEDs will
remain
ON
for a few seconds.
• The LEDs on the left front panel will turn
ON
at the same
time for about three seconds and then turn
OFF
.
•The
O
p
erate Handle
Write Protected
and
Use Cleanin
g
Ta
p
e
LEDs will turn
OFF
. The
Ta
p
e in Use
LED will
blink while the tape drive initializes.
• If your external SCSI bus terminator has a Term Power
LED it should also be illuminated.