Filter
Top Products
Advanced Digital Information Corporation FastStor 1
8 FastStor 1 Quick Installation Guide
Step 4. Removing the Transport Lock
The robot mechanism is protected from damage during shipment by a screw
holding the robotics in a locked position. This locking screw is marked with a red
plastic tab protruding between the right magazine and the front panel assembly.
This locking screw must be removed before the FastStor 1 can operate
normally.
Figure 10. Magazine lock marked with red plastic tab
The locking screw is detected when the FastStor 1 is powered on. The display
shows a message indicating the locking screw has been detected. The display
instructs the user to remove the magazine to gain access to the locking screw.
Remove the screw and reinsert the magazine. The loader will now continue its
power-on sequence. See Step 5.
Note: Keep the locking screw in a safe place. You will need it to lock the robot if
you must return your FastStor 1 to the supplier for service or repair.
Important: The warranty does not cover damage to the loader if the unit is shipped
without the locking screw properly installed.
Step 5. Running Power-On Selftest
After the transport lock is removed, the loader will continue running it’s power-on
selftest and performing an inventory of its cartridges.
The word “Idle” and the cartridge map will appear on the default display screen. If
the self-diagnostics and the inventory sequence complete successfully, the green
LED illuminates. The FastStor 1 is now ready to be installed in the system.
If a problem occurs during the power-on sequence, the FastStor 1 will show an
error message on the display.