Filter
Top Products
FastStor 1 Quick Installation Guide 1
Introduction
This guide is designed to enable quick installation of the ADIC FastStor 1
autoloader. For additional product and operation details, please refer to the ADIC
FastStor 1 Installation and User Manual.
The following steps summarize FastStor 1 installation:
• Unpack the FastStor 1
• Install the FastStor 1 in a rack
• Connect the power cable to the FastStor 1
• Turn on the FastStor 1
• Remove the transport lock by following the instructions displayed on the front
panel
• Select the appropriate SCSI IDs and unit options
• Connect the SCSI interface cable, and optionally the Ethernet cable
• Install the backup application software and configure it for use with the
FastStor 1
• Load cartridges into the removable magazines
In order to complete full installation of the FastStor 1, the following additional
materials are required:
• Simple hand tools (small Phillips screwdriver)
• SCSI Host adapter card with 68-pin wide HD or VHDC connector
• Tape application software that is verified with the FastStor 1
• Up to 8 pieces of the appropriate cartridge type to “stock” the FastStor 1 to full
capacity.