ADTRAN 1700611G2 Network Router User Manual


 
Unit Installation NetVanta 3100 Series Hardware Installation Guide
22 Copyright © 2012 ADTRAN, Inc. 61700600L2-34A
3. UNIT INSTALLATION
The instructions and guidelines provided in this section cover hardware installation topics, such as wall
mounting/rack mounting the unit and installing option cards. These instructions are presented as follows:
Mounting Options on page 22
Supplying Power to the Unit on page 24
For information on router configuration for a specific application, refer to the configuration guides provided on
the ADTRAN Support Community
. For details on the command line interface (CLI), refer to the AOS
Command Reference Guide. All other related documents are also available online at
http://supportforums.adtran.com
.
Tools Required
The customer-provided tools required for the hardware installation of the NetVanta 3100 Series are:
Ethernet cable
Phillips-head screwdriver
Mounting Options
The NetVanta 3100 Series can be installed in a wallmount or tabletop configuration.
Tabletop Mounting the NetVanta 3100 Series
For tabletop mounting, place the unit on a level surface within easy reach of an electrical outlet.
Wall Mounting NetVanta 3100 Series
The NetVanta 3100 Series units can be wall mounted. By following these instructions exactly, the
NetVanta can be safely mounted to the wall.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Ethernet cables are intended for intrabuilding use only. Connecting an ADTRAN unit
directly to Ethernet cables that run outside the building in which the unit is housed
will void the user's warranty and could create a fire or shock hazard. To connect an
ADTRAN unit to Ethernet cables that run outside the building, ADTRAN's Ethernet
Port Protection Device (EPPD) (P/N 1700502G1) must be connected between the
unit and the outside plant cable. Use of any Ethernet protector other than ADTRAN's
for this purpose will void the user's warranty.