Filter
Top Products
24
3. Console User Interface
3.1 Connecting to the Switch Console Port
User can configure the switch system via terminal emulation program through RS-232
port with baud rate 19200-8-n-1. The RS-232 connector is on the back panel of the switching
hub; make sure you connect the other end of serial port to COM1 of PC.
Note: When you use HyperTerminal with MS Windows 2000, make sure that you have
Windows 2000 Service Pack 2 or later are installed. Otherwise the arrow keys do not
function properly under HyperTerminal’s VT100 emulation.
3.2 Setup HyperTerminal
Please follow the steps to setup the HyperTerminal:
Step 1: Click Start Æ All Programs Æ Accessories Æ Communications Æ
HyperTerminal.