Airlink APSUSB201W Network Card User Manual


 
Section 1
Caution: Before beginning the installation, make sure that the printer driver is installed locally on each
computer that will print through the print server. Otherwise, the print server will not be configured
successfully. Please refer to your printer’s manual for instructions on how to install the printer driver.
Setup Preparation
Before setting up the print server, please take note of your TCP/IP setting.
Step 1 Click on Start, Run, and type command (for Windows 95/98/ME) or cmd (for Windows 2000/
XP) and click OK.
Step 2 At the command prompt, type ipconfig and press Enter.
Step 3 Write down the information for the IP Address, Subnet Mask, and Default Gateway. You will
need these information later. (This is the IP Address of your computer).