Filter
Top Products
7
This section describes how to connect the Switch to your network.
3.1 Connection
The Switch supports 8 10/100/1000Mbps Ethernet ports and all of
the 8 ports are PoE enabled ports. These PoE ports will
automatically activate when a compatible terminal is identified. The
Switch will supply power through the Ethernet port to the connected
PoE powered device (PD). For legacy devices that are not
compatible, the PoE port will not offer power to this device. This
feature allows users to freely and safely mix legacy and PoE devices
on their network.
The Switch supports 10Mbps Ethernet, 100Mbps Fast Ethernet and
1000Mbps Giga Ethernet; and it runs both in half and full duplex
mode using two pair of Category 5 cable. These RJ45 ports are
Auto-MDI type port. The Switch can auto negotiate the MDI-II or
MDI-X type, so you can connect any RJ45 cable regardless if it is a
standard or crossover cable.
3. Connecting the Switch