Filter
Top Products
35
After you clicked Apply, the following message will be displayed on your web browser:
You can click “Continue” to back to previous setup page to continue on other setup procedures,
or click “Apply” to reboot the router so the settings will take effect (Please wait for about 30
seconds while router is rebooting).
3.1.6 NAT
Network address translations solve the problem if sharing a single IP address to multiple
computers. Without NAT, all computers must be assigned with a valid public IP address to get
connected to Internet, but Internet service providers only provide very few IP addresses to every
user. Therefore it’s necessary to use NAT technology to share a single Internet IP address to
multiple computers on local network, so everyone can get connected to Internet.
Please follow the following instructions to set NAT parameters:
The NAT function is enabled by default; to disable, please select “Disable”. Do not disable NAT
unless you have professional knowledge on routing.
After you finish with all settings, please click “Apply” button.
If you want to reset all settings in this page, please click “Cancel” button.
After you clicked Apply, the following message will be displayed on your web browser: