Alacritech 100x1 Server User Manual


 
2-2 Alacritech 100 Series Hardware Installation Guide
2.2 Installing the Low Profile Bracket
The 100x1 Single-Port Server Adapter includes a low profile
bracket to facilitate installation in a low profile slot. To install a
100x1 Server Adapter in a low profile PCI slot, the bracket on the
rear of the card will need to be changed with the included low
profile bracket.
1. Remove the two 4-40 x 3/16 screws bottom side of the
card.
2. Install the low profile PCI bracket - P/N 9012, making
sure that the mounting tabs are on the bottom side of the
board and the screws secured from the component (top)
side. See Figure 3 for details.
To revert a 100x1 Server Adapter from low profile to standard PCI
the bracket on the rear of the card will need to be changed to the
original bracket.
1. Remove the two 4-40 x 3/16 screws from the topside of
the card.
2. Install the standard PCI bracket - P/N 6588, making
sure that the mounting tabs are on the top (component)
side of the board and the screws secured from the
bottom side. See Figure 3 for details.