Filter
Top Products
8 Patch Release Note
Patch 86222-27 for Software Release 2.2.2
C613-10319-00 REV Z
A log message is now created when a user is forced to logout from an
asynchronous port when another user (i.e. someone connected via Telnet)
resets the asynchronous connection with the RESET ASYN command.
Sometimes the Agent Address field in SNMP traps was not the same as the
IP source address. This meant that sometimes the NMS did not send an
alarm to the network manager when traps were received from switches.
This issue has been resolved.
Layer 2 packets transmitted out of the mirror port were being tagged
erroneously. This issue has been resolved.
DHCP sometimes suffered a fatal error when a range of IP addresses was
destroyed. This issue has been resolved.
Critical files (prefer.ins, config.ins and enabled.sec) are now copied from NVS
to FLASH at boot time if they do not exist in FLASH, or if the NVS version
of the file is different from the FLASH version.
If the SET SWITCH L3FILTER MATCH command had nothing specified for
the IMPORT and EMPORT parameters, and there was an existing match
entry in the filter table, the new filter was not added correctly. Filter match
entries are now accepted regardless of the order in which they are entered
into the table.
The DHCP lease Expiry time showed incorrectly in the SHOW DHCP
CLIENT command when the lease straddled across multiple months and
years. This issue has been resolved.
IP routes deleted from the route cache occasionally caused a fatal error. This
issue has been resolved.
PCR: 03332 Module: TTY Level: 2
PCR: 03346 Module: SNMP Level: 4
PCR: 03368 Module: SWI Level: 2
PCR: 03378 Module: DHCP Level: 2
PCR: 03385 Module: FILE, INSTALL, SCR Level:
PCR: 03386 Module: SWI Level: 2
PCR: 03388 Module: DHCP Level: 3
PCR: 03402 Module: IPG Level: