Filter
Top Products
Installing the Wall Mount Allied Telesyn 9100 Installation Safety
1-15
Telesyn 9100 Installation Guide (Installation of Allied Telesyn 9100)
Caution: The customer must ensure that the weight of a fully configured unit can be supported
by the mounting hardware/support used with the brackets.
1.6.2 Installing the Wall Mount
1.
Ensure there is enough space for the unit and associated cables
2.
Screw the brackets to the sides of the unit using the screws supplied in the kit.
3.
Locate and mark on the wall where the two holes where the top brackets will be mounted. Ensure the marks
are horizontal.
4.
Install two anchor screws/bolts, one for each top bracket.
5.
Hang the unit from these anchors
6.
Install the two bottom anchor screws/bolts, one through each bottom bracket.
7.
Tighten all anchor screws/bolts and bracket screws.
1.7 Allied Telesyn 9100 Installation Safety
1.7.1 Safety Guidelines
Note: Only personnel familiar with local telco practices should install, replace, or service this
equipment.
Note: Before starting the installation procedures, the user should read all of this section for important
safety information and warnings.
Before working on the equipment, the user should be aware of standard safety guidelines and the hazards
involved in working with electricity to avoid accidents. Follow these guidelines and warnings and those located
throughout this installation guide for a safe and hazard-free installation.
Follow these guidelines to ensure overall safety:
•
The user should keep all work areas clear and clean during and after installation.
•
The user should keep all tools away from walk areas where personnel could trip over them.
•
The user should not wear loose clothing that could catch on equipment. Secure any loose clothing.
•
The user should wear safety glasses if working under conditions that might be hazardous to eyes.
Before installing and cabling the equipment, the user should be aware
of standard safety practices and the hazards involved in working with
electricity to avoid accidents. See the following section, Safety Guide-
lines, for all cautions and warnings to insure that the installation is safe
and free of hazards.