Filter
Top Products
4 SwitchBlade Chassis and Fan Tray
C613-04029-01 REV C
■ Blank faceplates for all but one switch controller bay and one line card bay
(pre-installed at factory). That is, eight faceplates for the SwitchBlade 8 and
four faceplates for the SwitchBlade 4.
■ One blank faceplate for each PSU bay (pre-installed at factory).
■ Two rack-mount brackets (pre-installed at factory).
■ One 19 inch rack-mount kit.
■ Two RS-232 DB9 cables for connecting switch controller RS-232 ASYN0
ports to a terminal or PC.
■ Two Ethernet patch cables for connecting switch controller RJ-45 ETH0
ports to a terminal or PC.
■ One SwitchBlade Documentation and Tools CD-ROM (which includes the
complete SwitchBlade documentation set and utilities).
■ One SwitchBlade Chassis and Fan Tray Quick Install Guide.
■ One Safety and Statutory Information booklet.
■ One warranty card.
■ One cable manager with four wire loops (with the SwitchBlade 8 only).
■ One rack crossbar (to support the chassis’s weight during installation).
Related items that can be purchased separately:
■ Blank faceplates for switch controller and line card bays (AT-SB4193).
■ Blank faceplates for PSU bays (AT-SB4192).
■ Fan trays (AT-SB4152 for the SwitchBlade 8 or AT-SB4151 for the
SwitchBlade 4).
■ Blank faceplates for fan tray bays (AT-SB4191 for the SwitchBlade 8 or
AT-SB4194 for the SwitchBlade 4).
Selecting A Site
The chassis can be installed in a standard 19-inch rack or on a level surface
such as a sturdy bench. When installing the chassis, choose a site that:
■ allows adequate airflow around the chassis and its vents.
■ is free of dust and moisture.
■ will allow the chassis and its components to operate within a temperature
range of 0 to 40º C (32 to 104º F) and a humidity range of 5 to 95% non-
condensing.
■ has a reliable and earthed (grounded), preferably dedicated and filtered
power supply circuit.
■ does not expose cabling to sources of electrical noise, such as radios,
transmitters, broadband amplifiers, power lines, electric motors, and
fluorescent fixtures.
■ allows easy access to the chassis’s power and cable connections.
■ will allow all related network devices to be connected to the chassis
without exceeding maximum cable length limitations. See the SwitchBlade
Hardware Reference for cable length specifications.