Filter
Top Products
Installing the Hardware
28
Installing a Network Adapter Card
The following instructions apply to installing an AT-2701 series adapter
card in most systems. Refer to the manuals that were supplied with your
system for details about performing these tasks on your particular system.
To install the network adapter card, perform the following procedure:
1. Review the “Pre-Installation Checklist” on page 25 and “Reviewing
Safety Precautions” on page 23.
Before installing the adapter card, ensure the system power is OFF
and unplugged from the power outlet, and that proper electrical
grounding procedures have been followed.
Warning
High voltage inside the system presents a safety hazard. Make sure
the power is off before removing the cover.
2. Remove the system cover and select any empty PCI slot. See
Figure 8.
If you do not know how to identify a PCI slot, refer to your system
documentation.
Figure 8. Removing the PC Cover