Filter
Top Products
AT-9400 Series Gigabit Ethernet Switches Installation Guide
53
Installing the Power Cord Retaining Clip (AC Switches Only)
Perform the following procedure to install the power cord retaining clip on
the AT-9400 Switch:
1. Locate the power cord retaining clip, as shown in Figure 15.
Figure 15. Power Cord Retaining Clip
2. Install the clip on the AC power connector on the back panel of the
switch. With the “u” of the clip facing down, press the sides of the clip
toward the center and insert the short ends into the holes in the
retaining bracket, as shown in Figure 16.
Figure 16. Inserting the Retaining Clip into the Retaining Bracket
100-240VAC
~
100-240VAC
~