Filter
Top Products
18 SHOW IP IGMP Patch Release Note
Patch 86253-04 for Software Release 2.5.3
C613-10382-00 REV C
Multicast traffic will only be forwarded to ports identified as members of the
specific multicast group.
This enhancement allows network managers to prevent specified ports from
acting as IGMP all-group ports, and specify which ports are allowed to behave
as all-group entry ports, by using the ENABLE IP IGMP ALLGROUP
command.
For example, consider a video streaming service which has 15 channels. When
the switch receives IGMP membership reports destined for the address
239.0.0.2 from an unauthorised user, all 15 channels of multicast data floods to
that port, which may affect the service of the network. In order to avoid this,
the network manager decides whether or not to allow a particular port to
behave as an IGMP all-group port, e.g. port 8. Then, whenever the above IGMP
membership report is sent, the switch will not automatically add port 8 as one
of the egress ports for any IGMP membership report group, so video streaming
will not get forwarded to disabled all-group ports selected by the network
manager.
Commands
This enhancement modifies one command:
■ SHOW IP IGMP
and has two new commands:
■ ENABLE IP IGMP ALLGROUP
■ DISABLE IP IGMP ALLGROUP
Modified Command
SHOW IP IGMP
Syntax SHOW IP IGMP [COUNTER] [INTERFACE=interface]
Description This command displays information about IGMP, and multicast group
membership for each IP interface.
This enhancement includes the line “Disabled All-groups ports” on the output
of this command, as show in Figure 2 on page 19. Ports that are disabled have a
“#” symbol next to the port number.