Filter
Top Products
4 Patch Release Note
Patch 86253-04 for Software Release 2.5.3
C613-10382-00 REV C
BGP routes that were added after a summary aggregate route had been
formed were not suppressed. This issue has been resolved: all routes added
after summary aggregate route creation are also now suppressed.
The SHOW BGP ROUTE command displayed unselected routes as the
"best" route, until they had been processed. This issue has been resolved.
When a single route was deleted from an aggregate route, the aggregate
route was deleted, even if it contained other routes. This issue has been
resolved.
The time recorded when a user logged in was overwritten when the same
user logged in a second time while the original connection was still active.
This meant the SHOW USER command displayed the same time for both
connections. This issue has been resolved.
When an oversize packet (PMTU) was received, an error message was not
returned, even when IPv6 flow was enabled. This issue has been resolved.
With static multicasting enabled on two VLANs, only the first few multicast
packets of a stream were L3 forwarded. This issue has been resolved.
The MLD snooping entries registered on a port were not removed when the
port went down or was unplugged. This issue has been resolved.
Route flapping occurred with BGP when an interface went down. This issue
has been resolved.
When ingress rate limiting was used on Rapier switch ports, TCP sessions
sometimes obtained a throughput that was lower than the configured
ingress rate limit. This issue has been resolved.
If a configuration file had a long file name, the SHOW CONFIG command
displayed the file name using the shortened DOS 8.3 format (where file
names are 8 characters long, with extensions of 3 characters). This issue has
been resolved so that long configuration file names are now displayed using
the DOS 16.3 format (where file names are up to 16 characters long).
When a 4-port ETH PIC card was installed, the output of the SHOW IP
INTERFACE command showed the ETH port as Down, but the link LEDs
on the card were lit. This issue has been resolved. The SHOW command
now shows the correct link status. The link will go down after 90 seconds if
no inbound traffic is received. When inbound traffic is received the link will
come up.
PCR: 03723 Module: BGP Level: 2
PCR: 03726 Module: TTY, USER Level: 3
PCR: 03733 Module: IPV6 Level: 3
PCR: 03734 Module: IPG Level: 2
PCR: 03751 Module: MLDS Level: 3
PCR: 03757 Module: BGP Level: 2
PCR: 03771 Module: SWI Level: 2
PCR: 03780 Module: INSTALL Level: 3
PCR: 03789 Module: ETH Level: 2