Filter
Top Products
Note:
1. S1-2 and S1-3 will take effect only when S1-1 is set to TP-Force
2. S1-5 must be set to 100FDX for Single Fibre Model
3. S1-6 must be set to POE when you need to supply power to a PD.
Warning:
- When the copper port is set to AUTO and is connected to a device that
is forced to 100Mbps FDX, an unknown state may result.
- Please ensure that all network nodes that this device connects to are
set to the same mode at each end of the link.
e.g., Both ends are set to Auto-Negotiation mode (AUTO)
9. Cable Distances and Limitations
- TP Cable Limitations: Cat 5 up to 100m
- Fibre Cable Limitations:
SC/ST Converter Models
Multi Mode Half Duplex 412m
Multi Mode Full Duplex 2Km
Single Mode Half Duplex 412m
Single Mode Half Duplex 5/20/40/60/80/100Km
10. Technical Specifications
Standards:
IEEE 802.3u 10/100Base-TX, 100Base-FX
IEEE 802.3af Power Over Ethernet
UTP Cable:
Cat. 5 cable up to 100m
Fibre Cable:
50/125, 62.5/125 or 100/140 µm multi mode
8.3/125, 8.7/125, 9/125 or 10/125 µm single mode
Power Feeding
Support:
Via TP Pins 1, 2, 3 and 6
LED Indicators:
Power, POE, TP LNK/ACT, 100, FX LNK/ACT,
FDX/COL, 4W, 7W, 15.4W
Data Transfer Rate:
100Mbbps – 148,800pps
10Mbps – 14,880pps
Flow Control:
IEEE 802.3x compliant for Full Duplex
Backpressure flow control for Half Duplex
Power Requirements:
AC 100 ~ 240V 50 ~ 60Hz
Power Consumption:
24W
Ambient Temperature:
0º to 50º C
Humidity:
5% to 90%
Dimensions:
40(H) x 158(W) x 133(D) mm
Complies with C-Tick, FCC Part 15 Class A and CE Mark